SPECIAL OFFER - BOTH PUMP AND 10 METRE HOSE AT A DISCOUNTOUNTED RATE
Professional Stainless Steel Hyundai Submersible Pump for emptying hot tubs, spas and swimming pools.
Rather than wait hours for gravity to drain the tub, this pump will remove the water in minutes. The float will stop the pump when the tub is empty other than some water in the footwell. Then using a sponge push the water out of the seat hollows into the footwell, hold the float back up to turn the pump back on. This will now fully empty your water down to about 10mm. Use a sponge to mop the floor, then hose back in and refill.
This pump enables a rapid turn around especially essential for commercial premises and holiday cottages who have to changeover the water weekly for the new guests arriving.
Also if the sanitizer is zero in the water, then you can direct the outlet hose to water the garden, lawn or pump direct into your drain/gully.
Rated at 400 watts it can transfer 7500 litres/hour, so with a tub holding around 1200 litres it will take under 10 minutes.
The hose outlet allows for 25mm - 32mm hose to be connected to it for discharge.
The maximum height it can pump (Max Head) is 7 metres.
Supplied with a 13amp, 3 pin plug fitted and 10 metres of cable.
INCLUDING the hose:
A 10 metre length of quality reinforced hose for use with submersible pumps.
A cheap hose option often seen is lay flat hose although it kinks and kicks around when using with a submersible pump. We recommend this hose as it stays in position allowing you to leave it discharging. Great when you are doing a hot tub water change as you can wipe the waterline and clean the filter ready to then refill the hot tub.
38mm outside diameter. 32mm inside diameter.
SPECIAL OFFER - BOTH PUMP AND 10 METRE HOSE AT A DISCOUNTOUNTED RATE
Professional Stainless Steel Hyundai Submersible Pump for emptying hot tubs, spas and swimming pools.
Rather than wait hours for gravity to drain the tub, this pump will remove the water in minutes. The float will stop the pump when the tub is empty other than some water in the footwell. Then using a sponge push the water out of the seat hollows into the footwell, hold the float back up to turn the pump back on. This will now fully empty your water down to about 10mm. Use a sponge to mop the floor, then hose back in and refill.
This pump enables a rapid turn around especially essential for commercial premises and holiday cottages who have to changeover the water weekly for the new guests arriving.
Also if the sanitizer is zero in the water, then you can direct the outlet hose to water the garden, lawn or pump direct into your drain/gully.
Rated at 400 watts it can transfer 7500 litres/hour, so with a tub holding around 1200 litres it will take under 10 minutes.
The hose outlet allows for 25mm - 32mm hose to be connected to it for discharge.
The maximum height it can pump (Max Head) is 7 metres.
Supplied with a 13amp, 3 pin plug fitted and 10 metres of cable.
INCLUDING the hose:
A 10 metre length of quality reinforced hose for use with submersible pumps.
A cheap hose option often seen is lay flat hose although it kinks and kicks around when using with a submersible pump. We recommend this hose as it stays in position allowing you to leave it discharging. Great when you are doing a hot tub water change as you can wipe the waterline and clean the filter ready to then refill the hot tub.
38mm outside diameter. 32mm inside diameter.
